Some Claro Walnut Slabs

2/28 .. the three slabs with one coat of linseed oil

Close up

2/26 ...Oiling the first of the three slabs earlier this afternoon ... Click the photos to enlarge them ..

In the last year or so, I've had a couple of clients interested in tables made from big slabs of wood and we did make one from a huge claro walnut slab from Goodhope Hardwoods, but I haven't convinced anyone to bite the bullet buy one of my slabs yet. I've had these three in the rough since 2006. People would look at them, hmmm around a little bit, but end up passing. It was, I think, too hard for them to see the potential in those big rough boards in the somewhat dark upstairs of my garage. I even have a picture of a cardboard mockup I made for a potential client on my website. No luck ... This time, I decided I would just go ahead and sand and scrape them up so a potential client can see exactly what they might be getting. I don''t think I'll regret it ... They're looking pretty good.

#2

Butterfly keys for the cracks

A little more sanding and we'll put the oil to it

Slab #2 ... This is what they look like after they go through the widebelt. Sanding out all the roughness on the widebelt would have made them a bit thinner and I think we'll like the 'wavy' texture of 'not perfectly flat' table top just fine

Here's the cardboard mockup I made for an 'almost' client last year

I also found this 32" wide piece of cherry I forgot I had. It's got about 6 and a half good feet in it and then there's some funky stuff at one end. It's also got a little bruise that wll need some creative attention too, but overall, it's got some subtle figure and will eventually make somebody something pretty nice ...