another oval walnut pedestal table

while we're on the subject and we only have a couple more outs to go in the world series, here are some photos of the other walnut pedestal table that trevor's working on.  final sanding and staining start tomorrow ...
update 11/10

good to go .. it's headed to the islands via miami .. wouldn't mind delivering it myself ...

loyal readers might recognize the larger version below from a blog post back in 2010.

that one was quite a bit larger at 60 x 86, but the concept and the execution is pretty much the same.

make the base and top and top of the base ..

determine the height of the pedestal parts and make the patterns.  use the scale model to determine if the patterns are correct.  note that to make the miters meet, we had to add a small straight section to the curve as the top is a different proportionat 40 x 60 .. 2/3, rather than 3/4

trevor made the scale model base parts from 13/16ths poplar and painted them and once they were fitted up, enlarged the design on the cnc and made the full size patterns ...

we're going with the dark finish ..

 TWO OUTS IN THE 9TH!  looking good for the sox ... table's looking good too, ready for final sanding and the first coats of stain tomorrow.

seats six good friends .. paper is 11 x 17 .. saw blades are 10"

2 and 2 with two outs.  i think the red sox are gonna win it ... and they just did ... i think i'll go jump up and down a  bit ..

new table design

A client sent me some links recently to tables that she had seen online that she kind of liked but not exactly ... The size she was looking for (60 x 86) was not a standard one for most manufacturers so, I made a drawing for her. Working with ovals to define the curves, I played around with the proportions until I arrived at something that had some promise .. I got her ok for the concept and gave the drawing to Trevor, who cnc'd up a quick 1/6th scale model to look at. After a little more back and forth, we came to an agreement and we were off. Click the photos to enlarge them ...

The 1/6th model is on top of the bottom of the English elm table we finally finished this week ...
Without the top showing the interior 'flower' kind of concept ...
We started with 4 really nice wide boards of walnut from Irion Lumber ...
and after the top was glued up started in on the 16/4 pieces for the base. From the model drawing, Trevor made full sized patterns to help layout the cuts
After mitering them on the tablesaw, we added 3/4 inch hardwood dowels that passed through the center of each section to allow us to later run timberlock bolts up through the x cross base and into the four sections.
Before gluing up we also added some long grain walnut to reinforce the short grain out near the ends of the arcs. We tried a bunch of different approaches to clamping ...
and then hit on the idea of a cut out piece of plywood 'collar', clamps on the bottom, and cross clamps on the top, which allowed us to view the place where the four miters came together ... It all seemed good until we added the actual glue which for a minute turned the whole process into a small wrestling/clamp juggling match which we eventually won ...
Before adding the crossed base elements, Trevor routed and glued and screwed in a half inch baltic birch play reinforcing spider that gave us all confidence in the integrity of the glue up ...
A little more sanding and it will be off to the finish room next week ...
We're liking it and have already discussed a couple of variations on the theme ...